Planet SGSW-24040R User Manual page 101

•
Ingress Filtering
•
Accept Frame Type
•
Link Type
• Q-in-Q Mode
• Set Out layer VLAN tag
ether type
• Port VLAN ID
The port must be a member of the same VLAN as the Port VLAN ID.
untagged traffic will be dropped.
Enable ingress filtering for a port by checking the box. This parameter affects
VLAN ingress processing. If ingress filtering is enabled and the ingress port is not
a member of the classified VLAN of the frame, the frame is discarded. By default,
ingress filtering is disabled (no checkmark).
Determines whether the port accepts all frames or only tagged frames. This
parameter affects VLAN ingress processing. If the port only accepts tagged
frames, untagged frames received on the port are discarded. By default, the field
is set to All.
Allow 802.1Q Untagged or Tagged VLAN for selected port.
When adding a VLAN to selected port, it tells the switch whether to keep or
remove the tag from a frame on egress.
• Untag: outgoing frames without VLAN-Tagged.
• Tagged: outgoing frames with VLAN-Tagged.
Sets the Managed Switch to QinQ mode, and allows the QinQ tunnel port to be
configured. The default is for the Managed Switch to function in Disable mode.
• Disable
The port operates in its normal VLAN mode.
(This is the default.)
• MAN Port:
Configures IEEE 802.1Q tunneling (QinQ) for an uplink
port to another device within the service provider network.
• Customer Port:
Configures IEEE 802.1Q tunneling (QinQ) for a client
access port to segregate and preserve customer VLAN
IDs for traffic crossing the service provider network.
The Tag Protocol Identifier (TPID) specifies the ethertype of incoming packets
on a tunnel access port.
• 802.1Q Tag : 8100
• vMAN Tag : 88A8
Default : 802.1Q Tag
Configures the VLAN identifier for the port. The allowed values are 1 through
4095. The default value is 1.
101
User's Manual of WGSW-24040 / WGSW-24040R
SGSW-24040 / SGSW-24040R