Table of Contents
Advertisement
6. Configure IP Address
The IP address configuration commands for VLAN1 interface are listed below.
Before in-band management, the Managed Switch must be configured with an
IP address by out-of-band management (i.e. Console mode), the configuration
commands are as follows (All switch configuration prompts are assumed to be
"XGS3-24042" hereafter if not otherwise specified):
XGS3-24042>
XGS3-24042> enable
XGS3-24042# config
XGS3-24042 (config)# interface vlan 1
XGS3-24042 (Config-if-Vlan1)# ip address 192.168.1.254 255.255.255.0
The previous command would apply the follow settings for the Managed Switch.
IPv4 Address: 192.168.1.254
Subnet Mask: 255.255.255.0
To check the current IP address or modify a new IP address for the Switch, please
use the procedures as follow:
8
Figure 6-1 Configure IPv4 address screen
Advertisement
Table of Contents
