The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the CLI command
modes are described below. Each of the command modes supports specific software commands.
Command Groups:
System
IP
Port
Aggr
LACP
RSTP
Dot1x
IGMP
LLDP
MAC
VLAN
PVLAN
QoS
ACL
Mirror
SNMP
Stack
Firmware
6.1 System Command
System Configuration
Description:
Show system configuration.
Syntax:
System Configuration [all] [<port_list>]
Parameters:
System settings and reset options
IP configuration and Ping
Port management
Link Aggregation
Link Aggregation Control Protocol
Rapid Spanning Tree Protocol
IEEE 802.1X port authentication
Internet Group Management Protocol snooping
Link Layer Discovery Protocol
MAC address table
Virtual LAN
Private VLAN
Quality of Service
Access Control List
Port mirroring
Simple Network Management Protocol
Stack management
Download of firmware via TFTP
User's Manual of WGSW-24040 / WGSW-24040R
6. Command Line Mode
212
SGSW-24040 / SGSW-24040R