Monitor Unit - Furuno FAR-3230S(-BB) Installation Manual

2.5

Monitor Unit

For the wiring of the monitor unit, see the operator's manual supplied with the monitor
unit.
Installation consideration
<Standard type>
• Connect the main monitor to the DVI1 and COM1 ports.
• For the sub monitor, connect it to the DVI2 and COM2 port.
<VDR connection, ask your dealer>
To connect a VDR, it is necessary to output data in analog format. See the installation
manuals for VDR to prepare the cables to use.
• When connecting a VDR to the DVI3 port:
Use the optional DVI-BNCX5-L2000 cable to output RGB signal from the DVI-I. Ad-
justment of the output picture is necessary.
• When connecting a VDR to the DVI2 port:
Use a DVI/RGB converter (maker: IMAGENICS, type: DVI-12A, local supply) to
convert DVI output from DVI2 port to RGB.
Menu setting
The [INSTALLATION SETTING] menu appears only when the power is turned on for
the first time after installation of the monitor unit.
INSTALLATION SETTING
EXT BRILL CTRL
SERIAL BAUDRATE
COLOR CALIBRATION
KEY LOCK
SAVE AND EXIT
Adjust the settings referring to the following table.
EXT BRILL
CTRL
RS-485
*: [DVI PWR SYNC] is the slide switch at the bottom rear of the monitor unit. Confirm
that this switch is set to [ON] (default setting). See Slide switch below for details.
Slide switch
Set the slide switch to "ON"
(default setting). This setting
automatically powers the mon-
itor unit on or off according to
the DVI signal input. The pow-
er switch of the monitor unit is
inoperative.
Note: The OFF position provides control of the monitor unit power with the power
switch of the monitor unit.
RS-485 (OFF/DVI1/DVI2/RS-232C/RS-485/USB)
4800bps (4800/9600/19200/38400)
ON (OFF/ON)
ON (OFF/ON)
YES (NO/YES)
SERIAL COLOR
BAUDRATE CALIBRATION
4800bps
Slide switch
RGB
port
Menu
KEY LOCK
ON ON
ON (Default setting)
OFF
2. WIRING
Menu item
DVI PWR
SYNC*
ON
DVI
port
2-25