Mounting The Antenna Unit - Furuno DRS12AX X-Class Installation Manual

7. Apply adhesive to the holes and bolts at the locations indicated with arrows in the
figure below. Also apply adhesive to the junction between the radiator and the ra-
diator bracket.
Bolt assembly - side view (detailed)
Spring
washer
Hex. bolt
1.5

Mounting the Antenna Unit

The antenna unit can be mounted using the fixing holes on the outside (200 200 mm)
or inside (140
When 140
side fixing holes.
1. Set the supplied mounting template to the mounting location, then drill four fixing
holes in the mounting location.
Note: The holes must be parallel with the fore and aft line.
Mounting template
2. Apply adhesive to the thread of the stud bolts (M12 70, 4 pcs).
Note: Apply adhesive to the part of the bolt threads that are inside the bolt hole
(see the figure at step 3).
3. Insert four stud bolts into the threaded holes in the antenna unit.
The stud bolts must make contact with the bottom of the threaded holes.
Note: Do NOT cover the vent hole at the bottom of the unit.
Radiator
Flat washer
Adhesive
150 mm) the antenna unit. Normally, use the outside fixing holes.
150 mm fixing holes already exist on the mounting platform, use the in-
Bow Bow
1. INSTALLATION AND WIRING
Apply adhesive
to these bolts
and holes
Radiator - bottom view
7
Apply adhesive to the Apply adhesive to the
junction between the junction between the
radiator and radiator radiator and radiator
bracket. bracket.