Furuno FAR-3230S(-BB) Installation Manual page 43

Connection
1. Unfasten four screws (M4×8) to remove the top cover from the processor unit.
2. Unfasten the three bolts circled below to remove the upper plate of the cable
clamp.
J8 J8
J5 J5
J3 J3
J12 J12
J9 J9
J6 J6
J11 J11
J4 J4
J14 J14
J13 J13
J7 J7
J10 J10
Unfasten this bolt to use
the lower clamp holes.
Unfasten these three bolts to remove the upper plate.
3. Pass the cables through the clamp holes, then fasten the bolts removed at step 2
to fix the cables.
4. Connect the WAGO connectors to the I/O Board, referring to the interconnection
diagram. See the figure at step 2 for J13 and J14.
Processor unit, top view
Lay shields of cables
under this clamp then
tighten the clamp.
Clamp holes
(upper)
Clamp holes
(lower)
J12 (main control unit)
For J13 and J14 (sub
control units).
2. WIRING
2-15