Furuno FAR-3230S(-BB) Installation Manual page 52

2. WIRING
9. Connect the power line and the LAN cable as shown below.
Connect power line of Connect power line of
antenna cable to TB131 antenna cable to TB131
on PSU-TB Board. on PSU-TB Board.
For existing antenna
cable, ground unused
lines here.
10. Connect the shield
wires of the antenna
cable and serial cable
for processor unit to
each grounding point.
11. Remount the cable clamp assembly removed at step 2.
12. Remove the connector cover for the power cable (2 places).
13. Fabricate the power cable (DPYC-2.5) as shown below.
14. Pull up the plastic cover and connect the power ca-
ble.
15. Remount the connector cover for the power cable.
16. Reattach the cover of the power supply unit.
2-24
Connector cover of power cable
Vinyl tape
Armor Sheath (Clamp here.) Sheath (Clamp here.)
1 2 3 4 5 6 7 8 9 10 11 12 13
Clamp the armor.
Grounding point (for antenna cable) Grounding point (for antenna cable)
Grounding point Grounding point
(for serial cable for processor unit) (for serial cable for processor unit)
FV2-M4
25
35
30
Connect LAN cable of
antenna cable to J102
on PSU-CNTL Board.
Ground the LAN
cable.
Plastic cover