Antenna Unit - Furuno FAR-3230S(-BB) Installation Manual

2.2

Antenna Unit

Three cables are connected to the antenna unit: antenna cable, cable for the sub mon-
itor (option) and power cable for the deicer (option). The procedure shows how to con-
nect all cables. Disregard the descriptions for the optional equipment if not applicable.
Rear side
2.2.1 How to fabricate the cables
Antenna cable RW-00135
See "How to fabricate the LAN cable" on page 2-12 for how to attach the LAN cable
connector.
Remove the vinyl tape.
Armor Armor
Sheath Sheath
Antenna cable RW-9600/6895/4873 (for retrofit installation)
The optional LAN signal converter kit is required for retrofit installation. For wiring in
case of a retrofit, see section 2.7.
Sheath Sheath
10
For RW-9600: The white, red, and green wires are not used. Attach a single crimp-on
lug (FV5.5-S4(LF), yellow) locally to the wires. (These wires will be connected togeth-
er with the shield of the power line, in the next section.)
For RW-6895/4873: Fifteen wires are not used. Cut the wires and bind them with vinyl
tape. Do not connect the wires to ground.
Vinyl tape
Shield Shield
Sheath Sheath
10
30
Vinyl tape
Armor
Sheath
30
Cable for deicer
Cable for antenna
Cable for sub monitor
Antenna motor switch
14 9
5
2. WIRING
Power line
LAN cable
6
6
Shield Shield
Crimp-on lug
Coaxial Coaxial
cable cable
2-3