Furuno FAR-3230S(-BB) Installation Manual page 73

8. Connect the coaxial cable from the converter to the BNC case, passing through
the locking wire saddle.
Fasten the BNC case to the rail inside
the antenna unit with two screws.
2.7.3 Installation in the power supply unit
Some parts or wiring may have been omitted from the illustrations for clarity.
1. Fasten the converter then connect the coaxial cable to the BNC case (see step 6
of paragraph 2.7.2).
BNC case BNC case
2. Pass the LAN cable through the clamp
then connect it to J102 on the PSU-
CNTL board. (The cable will be con-
nected to the converter after the con-
verter is installed.)
3. Fasten the converter with three
screws. Attach the two supplied
locking wire saddles to the loca-
tions circled in the right figure.
Set the M_S
switch on the
converter to the M
(Master) position.
Connect the coaxial
cable to the BNC case.
Coaxial cable Coaxial cable Coaxial cable
Connect the coaxial cable to the BNC case,
passing through the locking wire saddle.
Connect LAN cable to J102.
Attach locking wire saddles.
1 2 3 4 5
1 2 3 4 5 6 7 8 9 10 11 12 13
2. WIRING
Fasten the
converter to the
mounting bracket
with four screws.
Fasten the BNC
case to the
mounting bracket
with two screws.
LAN LAN
Fasten
Signal Signal
unit with
Conv. Conv.
three
screws.
5
2-45