Furuno FAR-3230S(-BB) Installation Manual page 35

2) Unfasten four bolts to open the front cover. Remove the cover, being careful
not to hit the elements on the chassis or radiator.
3) Remove then pass the power cable from the cable entrance. Tighten the ca-
ble gland with a hook spaner wrench.
4) Wrap the supplied spiral tube around the
power cable for the de-icer, starting from the
crimp-on lugs. Set the supplied locking wire
saddle at location (6) in the right figure. Pass
the cable through locking wire saddles (1) to
(6).
5) Unfasten the cable band on the font cover.
Pass the cable for the de-icer through the band
then fasten the band. Connect the cable to TB901
on the DE-ICER board (03P9573), using the
crimp-on lugs supplied.
6) For 100-115V power supply, set the voltage selection switch to 115V. (default
setting: 230V) Turn on the power to the deicer then press the [TEST] button
about ten seconds. Check if the heater gets hot. Turn off the power to the de-
icer.
7) Fasten the front cover, then fasten the cable entrance for the DE-ICER. When
fastening the front cover, spread open the heater elements, lifting the base of
the heater. Take care not to hit the heater elements on the chassis or radiator.
2. WIRING
Spiral tube Spiral tube
03P9573
TB901
Cable Cable Cable Cable Cable
band band band band band
03P9573 Board
[TEST] button [TEST] button
Voltage Selection Switch
TB901
2-7