Furuno FAR-3230S(-BB) Installation Manual page 34

2. WIRING
6. Unfasten the cable gland for
the antenna cable (RW-
00135) and remove the gas-
ket and three flat washers.
7. Slide the cable gland,
the gasket and three
flat washers onto the
cable as shown in the
right figure.
8. Push the flat washer
against the armor.
9. Trim the armor so that
it does not extend past
the flat washers, then
pass the antenna ca-
ble through the cable
entrance.
10. If applicable, also pass the cable for the sub
monitor and the power cable for the deicer
through the cable entrance. Pass the cables
through their respective locking wire saddle.
11. Tighten the cable glands with the hook
spanner wrench.
Note: Use the wrench of the correct size. If
you do not have the hook spanner wrench,
contact our dealer.
12. Pull the cables out of the chassis other than the cable for de-icer. See step 13 for
the deicer.
13. DE-ICER INSTALLATION. If the de-icer is not provided, go to step 14 on page 2-
8. See "S-band DE-ICER Kit Installation Instructions", issued separately, for the
de-icer not fitted at the factory.
1) Remove four bolts then spread open the
right and left heater elements on the
front cover.
Note: Lift the elements slightly when
opening so as not hit the elements on the
bolts on the chassis.
2-6
Gland for Gland for
antenna cable antenna cable
Cable gland Flat washer Cable gland
Flat washer
Sheath Sheath
Outer sheath Outer sheath
Gasket Gasket
Flat washers Flat washers
Flat washer Flat washer
Inner sheath Inner sheath
Gasket Gasket
Push the flat washer
against the armor.
Trim the armor.
For power For power
cable of de-icer cable of de-icer
For Antenna For Antenna
cable cable
For Sub monitor For Sub monitor
cable cable