Installing Components; Installing An Acx1000 Or Acx1100 Transceiver; Chapter 14 Installing Components - Juniper acx1000 User Manual

CHAPTER 14

Installing Components

Installing an ACX1000 or ACX1100 Transceiver

Copyright © 2017, Juniper Networks, Inc.
Installing an ACX1000 or ACX1100 Transceiver on page 115
To install a transceiver:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
2.
on the component where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
3.
transceiver with a safety cap.
Carefully align the transceiver with the slots in the component. The connectors should
4.
face the component.
Slide the transceiver until the connector is seated in the component slot. If you are
5.
unable to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
6.
Remove the rubber safety cap from the transceiver and the end of the cable. Insert
7.
the cable into the transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Verify that the status LEDs on the front panel indicate that the transceiver is functioning
8.
correctly. For more information about the component LEDs, see the
and ACX1100 Routers" on page 35.
"LEDs on ACX1000
115