Table of Contents
Advertisement
3–Fibre Channel Configuration
Running Diagnostics—Fibre Channel Ping and Trace Route
Supported configurations for Fibre Channel ping and trace route include:
QLogic 2700 Series Adapters
Brocade Switches with Based Fabric OS
NOTE
The switch and the Fibre Channel end device must both support the Fibre
Channel ping and trace route feature. See
supported Fibre Channel software version.
Running a Fibre Channel CT Ping Test
You can run a Fibre Channel CT ping test from QConvergeConsole GUI,
QConvergeConsole CLI, or the QConvergeConsole VMware plug-ins, as
described in this section.
Running a Fibre Channel CT Ping from QConvergeConsole GUI
To run a Fibre Channel CT ping test from QConvergeConsole GUI:
1.
In the QConvergeConsole GUI left pane, click the Host tab.
2.
On the Host page, expand the adapter node and then select a port.
3.
In the content pane on the right, click the Diagnostics tab.
4.
On the Diagnostics page, click the General Diagnostics tab.
(FOS) v6.0.0a
®
Table 3-10 on page 93
77
for the
BK3254601-00 C
Advertisement
Table of Contents
Troubleshooting
