Configuring Virtual Ports (Npiv); Configuring Npiv With Qconvergeconsole Gui; Configuring Npiv With Interactive Qconvergeconsole Cli; Configuring Npiv With Noninteractive Qconvergeconsole Cli - Qlogic QLE2740L-DEL User Manual

3–Fibre Channel Configuration

Configuring Virtual Ports (NPIV)

Configuring Virtual Ports (NPIV)

Use QConvergeConsole to configure virtual ports for N_Port ID virtualization and
quality of service:


Configuring NPIV with QConvergeConsole GUI



Configuring NPIV with Interactive QConvergeConsole CLI



Configuring NPIV with Noninteractive QConvergeConsole CLI

 Configuring NPIV Quality of Service
Configuring NPIV with QConvergeConsole GUI
For information about using virtualization (NPIV) in QConvergeConsole GUI, refer
to in the QConvergeConsole Help.
To access the QConvergeConsole Help system while the GUI utility is running,
point to the gear icon
Contents. To install QConvergeConsole GUI, see
GUI" on page
Configuring NPIV with Interactive QConvergeConsole CLI
For information about using virtualization (NPIV) in the interactive mode of
QConvergeConsole CLI, refer to the User's Guide—QConvergeConsole CLI (part
number SN0054667-00). To download the guide, go to
Downloads.
Configuring NPIV with Noninteractive QConvergeConsole CLI
To create a virtual port with an automatic WWPN using the noninteractive mode of
QConvergeConsole CLI, issue the following command:
# qaucli -pr fc -vp (<hba instance> | <hba wwpn>) create auto
Where:
hba instance = Adapter number (use the -g command to find)
hba wwpn = Worldwide port name of the adapter
For more information, refer to the section about Fibre Channel noninteractive
commands in the User's Guide—QConvergeConsole CLI (part number
SN0054667-00).
, point to Help, and then click then click Browse
112.
47
"Installing QConvergeConsole
www.qlogic.com
BK3254601-00 C
and click