Checking D_Port Results From A Brocade Fibre Channel 16G Or; Switch - Qlogic QLE2740L-DEL User Manual

A–Troubleshooting
Troubleshooting with a Diagnostic Port (D_Port)
To disable D_Port diagnostic mode:
From the Brocade Fibre Channel 16G or 32G switch, issue the following
commands:
# portdisable <port_num>
# portcfgdport ––disable <port_num>
# portenable <port_num>
The D_Port test stops.
Checking D_Port Results from a Brocade Fibre Channel 16G
or 32G Switch
To view the D_Port test results from a Brocade Fibre Channel 16G or 32G

switch:

1. To get the port number, issue the switchshow command:
# switchshow
The following example output identifies port 17:
17
2. Issue the portdporttest command as follows:
# portdporttest --show <port_num>
For example:
# portdporttest --show 17
Following is an example output for this command.
portdporttest --show 17
D-Port Information:
===================
Port:
Remote WWPN:
Mode:
No. of test frames:
Test frame size:
FEC (enabled/option/active):
CR (enabled/option/active):
Start time:
End time:
Status:
==============================================================================
Test
17 011100 id N16
17
21:00:00:0e:1e:11:4a:31
Automatic
1 Million
1024 Bytes
Yes/No/No
Yes/No/No
Thu Aug 14 01:45:37 2014
Thu Aug 14 01:47:40 2014
PASSED
Start time
Online FC D-Port Loopback->Port 17
Result EST(HH:MM:SS)
104
Comments
BK3254601-00 C