Table of Contents
Advertisement
3–Fibre Channel Configuration
Configuring and Verifying FA-BLD
Figure 3-25
Figure 3-25. Configuring Adapter and Boot Device
Configuring a Zone in a Brocade Switch
To configure a zone in a Brocade switch:
1.
Create a boot LUN configuration as follows:
bootluncfg --add 50:00:53:37:63:FA:00:05
20:02:00:11:0d:51:5c:01 0000000000000000
2.
Create a zone named with the following:
3.
Add a zone to the zoneset configuration as follows:
cfgadd config, "BFA_5000533763fa0005_BLUN"
4.
To save the zoneset, issue the following command:
cfgsave
5.
Enable zoneset configuration to have it actively running:
cfgenable config
shows an example of the adapter and boot device configuration.
Device's PWWN
Specific information about the target WWN
LUN to be booted from
71
BK3254601-00 C
Advertisement
Table of Contents
Troubleshooting
