3–Fibre Channel Configuration
Configuring End-to-End CS_CTL QoS
This command should return the following response:
fos.csctlMode:1
5.
To enable QoS on a switch-port basis, issue the following command:
portcfgqos --enable [slot/]port csctl_mode
Configuring CS_CTL QoS on the Storage Device
See your device's user guide for QoS configuration instructions.
Changing the QoS Priority Levels
The QoS priority levels are set in the 2700 Series Adapters vPorts. The Windows
and VMware adapter drivers assign default vPort priority levels. The following
sections describe how to change the default vPort priority levels in Windows and
VMware ESXi systems.
Changing the Priority Levels in Windows
To change the vPort priority levels in Windows, you must first assign the vPorts,
and then change the priority levels. Both procedures can be accomplished using
either QConvergeConsole GUI or interactive QConvergeConsole CLI, as
described in the following sections.
For more detailed information, see the QConvergeConsole Help and the User's
Guide—QConvergeConsole CLI (part number SN0054667-00).
Creating a Vport
To create a vPort in QConvergeConsole GUI:
1.
In the QConvergeConsole GUI left pane, connect to the host that has the
2700 Series Adapters where you want to create the vPorts.
2.
Expand the host in the left pane by clicking the plus sign (+).
3.
Locate and expand the 2700 Series Adapters where you want to create the
vPorts.
4.
In the right pane, click the Virtual tab.
5.
Enter a valid value for the Number of vPort to create option, and then click
Update.
6.
To create the vPorts, click Create.
86
BK3254601-00 C