Fibre Channel Configuration - Qlogic QLE2740L-DEL User Manual

3

Fibre Channel Configuration

This chapter provides the following information about configuring Fibre Channel:



















NOTE
"Updating the Dell Firmware" on page 33
"Using Fast!UTIL for Custom Configuration" on page 36
"Setting Fibre Channel Adapter Parameters" on page 43
"Configuring Target Persistent Binding" on page 44
"Configuring Boot Devices" on page 45
"Configuring Virtual Ports (NPIV)" on page 47
"Configuring Fibre Channel Driver Parameters" on page 53
"Configuring Selective LUNs" on page 54
"Configuring OoOFR" on page 55
"Configuring the UEFI Driver" on page 56
"Setting an FA-PWWN" on page 63
"Configuring and Verifying FA-BLD" on page 68
"Using a Fabric-Assigned Boot LUN" on page 73
"Running Diagnostics-Fibre Channel Ping and Trace Route" on page 76
"Configuring CS_CTL QoS" on page 81
"Configuring End-to-End CS_CTL QoS" on page 84
"Configuring FDMI" on page 90
"Enabling QLogic Forward Error Correction" on page 94
"Running Extended Link Service Commands" on page 96
For information on configuring the Fibre Channel Adapter using VMware
vCenter Server, refer to the User's Guide-QConvergeConsole Plug-ins for
VMware vSphere (part number SN0054677-00), available at:
http://driverdownloads.qlogic.com
32 BK3254601-00 C