Installation Overview; Installing The Esxi 6.5 And 6.0 U2 Fibre Channel Driver; Updating An Existing Driver Or Installing A New Driver For An Existing Esxi 6.5 Or 6.0 U2 Installation With Esxcli - Qlogic QLE2740L-DEL User Manual

2–Driver Installation and Configuration
VMware Driver Installation and Configuration

Installation Overview

To install and configure the adapter drivers on a VMware system, refer to the
driver release notes and readme files included in the package.

Installing the ESXi 6.5 and 6.0 U2 Fibre Channel Driver

The operating system manages and controls the driver installation process. To
install the ESXi driver, follow the steps in this section.
NOTE
This section provides the most common ways of installing and upgrading the
driver. For other installation procedures, consult the operating system
manuals and the driver readme file.
This section provides procedures for the following:
 "Updating an Existing Driver or Installing a New Driver for an Existing ESXi
6.5 or 6.0 U2 Installation with esxcli" on page 17
 "Verifying the Version of the Installed Driver" on page 18
Updating an Existing Driver or Installing a New Driver for an Existing ESXi 6.5
or 6.0 U2 Installation with esxcli
To use the driver bundle <offline-bundle>.zip):
1. Copy the driver bundle (<offline-bundle>.zip) to this ESXi host.
2. Install the driver bundle (<offline-bundle>.zip) as follows:
a.
b.
c.
To use the driver VIB:
1. Copy the driver VIB to this ESXi host by issuing the following command:
qlnativefc-<driver-version>.0.0.<esx-build>.x86_64.vib
To create a temporary directory, issue the following commands:
mkdir /install
cd /install
Unzip the driver bundle in the temporary directory:
/install : unzip <offline-bundle>.zip
Issue the following command:
esxcli software vib install -n qlnativefc -d /install
17 BK3254601-00 C