Installing The Adapter; Connecting To The San - Qlogic QLE2740L-DEL User Manual

1–Hardware Installation

Installing the Adapter

Installing the Adapter
To install the QLE274x-DEL Adapters:
1. Power off the computer and all attached devices such as monitors, printers,
and external components.
2. Disconnect the power cable.
3. Remove the computer cover and find an empty PCIe bus slot. For more
information about selecting a bus slot, see
on page
4. Pull out the slot cover (if any).
5. Grasp the adapter by the top edge and seat it firmly into the appropriate slot.
6. Refasten the adapter's retaining bracket.
7. Close the computer cover.
8. Plug the Fibre Channel cable into the adapter.
9. Plug in the power cable and turn on the computer.
For more detailed information, refer to the Hardware Owner's Manual for your Dell
PowerEdge server.

Connecting to the SAN

To connect the QLE274x-DEL Adapters to the SAN, refer to the Hardware
Owner's Manual for your Dell PowerEdge server.
2.
3
"PCIe Bus Slot Considerations"
BK3254601-00 C