Configuration Settings; Adapter Settings - Qlogic QLE2740L-DEL User Manual

3–Fibre Channel Configuration
Using Fast!UTIL for Custom Configuration
5. To load the new parameters, reboot the system.
CAUTION
If the configuration settings are incorrect, your 2700 Series Adapter may not
function properly.
The Fast!UTIL Options menu provides the following options:
 "Configuration Settings" on page 37
 "Scan Fibre Devices" on page 41
 "Fibre Disk Utility" on page 42
 "Loopback Data Test" on page 42
 "Select Adapter" on page 42
 "Exit Fast!UTIL" on page 42

Configuration Settings

The following sections show and describe the 2700 Series Adapters
Configuration Settings menu options in Fast!UTIL:
 "Adapter Settings" on page 37
 "Selectable Boot Settings" on page 39
 "Restore Default Settings" on page 40
 "Raw NVRAM Data" on page 40
 "Advanced Adapter Settings" on page 40

Adapter Settings

Table 3-1
Setting Values
Enabled,
Host Bus
Disabled
Adapter BIOS
512, 1024,
Frame Size
2048
describes the adapter settings.
Table 3-1. Adapter Settings
Default
Disabled Disabling this setting disables the ROM BIOS on the 2700
Series Adapter, which frees space in upper memory. If you
are booting from a Fibre Channel disk drive attached to the
2700 Series Adapter, you must enable this setting. See
"Selectable Boot Settings" on page 39
ing the boot device.
2048 This setting specifies the maximum frame length supported
by the 2700 Series Adapter.
Description
37
for details on specify-
BK3254601-00 C