Error Code Table - Teledyne EV71YC1MCL2010-BA0 User Manual

6.2.4 Error code table

The error codes returned by the camera are compliant with the GenCP standard :
Status Code (Hex) Name
0x0000 GENCP_SUCCESS
0x8001 GENCP_NOT_IMPLEMENTED
0x8002 GENCP_INVALID_PARAMETER
0x8003 GENCP_INVALID_ADDRESS
0x8004 GENCP_WRITE_PROTECT
0x8005 GENCP_BAD_ALIGNMENT
0x8006 GENCP_ACCESS_DENIED
0x8007 GENCP_BUSY
0x800B GENCP_MSG_TIMEOUT
0x800E GENCP_INVALID_HEADER
0x800F GENCP_WRONG_CONFIG
0x8FFF GENCP_ERROR
U M UNIIQA+ M
SER ANUAL ONOCHROME
Description
Success
Command not implemented in the device.
At least one command parameter of CCD or SCD is invalid
or out of range.
Attempt to access a not existing register address.
Attempt to write to a read only register.
Attempt to access registers with an address which is not
aligned according to the underlying technology.
Attempt to read a non-readable or write a non-writable
register address.
The command receiver is currently busy.
Timeout waiting for an acknowledge.
The header of the received command is invalid. This
includes CCD and SCD fields but not the command
payload.
The current receiver configuration does not allow the
execution of the sent command.
Generic error.
– R J – 05/2017
EV
P | 19
A G E