Teledyne EV71YC1MCL2010-BA0 User Manual page 58

Defect
CommCam Can't find the Camera :
After launching CommCam, the Icon of
the Camera is not visible.
An Teledyne-e2v Camera is detected
but not identified :
A "question Mark" icon appears in place
of the one of the AVIIVA2
Impossible to connect to the identified
Camera :
The message "Impossible to open
device" is displayed
Error messages is displayed just
after/before the connection :
U M UNIIQA+ M
SER ANUAL ONOCHROME
Detail
– R J – 05/2017
EV

The Camera is not powered up or
the boot sequence is not finished.

The CameraLink cable is not
connected or connected on the
bad connector.

Check if the CameraLink libraries
(clallserial.dll and clserXXX.dll) are
in the same directory (either
system32 or program
files/cameralink/serial)

The Frame Grabber is compliant
with CameraLink standard 1.1
>


The version of CommCam used is too
old : You have to use the version
1.2.x and after.


There is a possible mismatch
between the major version of xml
file used by CommCam and the
firmware version of the Camera

Possible Hardware error or
Camera disconnected after being
listed.
>

There is a possible mismatch
between the minor version of xml
file used by CommCam and the
firmware version of the Camera

Default values of the Camera out
of range
>
Solutions
Contact the hotline :
hotline-cam@Teledyne-
e2v.com
Contact the hotline :
hotline-cam@Teledyne-
e2v.com
Contact the hotline :
hotline-cam@Teledyne-
e2v.com
P | 58
A G E