Status Led Behaviour; Cameralink Output Configuration - Teledyne EV71YC1MCL2010-BA0 User Manual

3.2.3 Status LED Behaviour

After less than 2 seconds of power establishment, the LED first lights up in ORANGE. Then after a Maximum
of 3 seconds, the LED must turn in a following colour :
Colour and state
Green and continuous
Green and blinking slowly
Red and continuous
Orange and Continuous

3.2.4 CameraLink Output Configuration

Output Configuration
Version "Essential"
Base : 1 Channel 8/10/12bits
Base : 2 Channels 8/10/12bits
Version "High Speed"
Base : 1 Channel 8/10/12bits
Base : 2 Channels 8/10/12bits
Medium : 4 Channels 8/10/12bits
Full : 8 Channels 8bits
Deca : 10 Channels 8bits
-
NR : Not required as the fastest speed (100kHz) is already achieved by the precedent output mode with the
lowest data rate (ex : 100kHz is achieved on 512 pixel in base mode with 2 x 42.5Mhz. Medium is not
required, even for 10bits.
U M UNIIQA+ M
SER ANUAL ONOCHROME
Meaning
OK
Waiting for External Trigger (Trig1 and/or Trig2)
Camera out of order : Internal firmware error
Camera booting or upgrading
Channels
1 x 85MHz
(60/42.5MHz)
2 x 85MHz
(60/42.5MHz)
1 x 85MHz
(60/42.5MHz)
2 x 85MHz
(60/42.5MHz)
4 x 85MHz
(60/42.5MHz)
8 x 85MHz
(60/42.5MHz)
10 x 42.5MHz
(60/85MHz)
– R J – 05/2017
EV
Pixels per Channel
4k 2k
1 x 4096 1 x 2048 1 x 1024
2 x 2048 2 x 1024 2 x 512
1 x 4096 1 x 2048 1 x 1024
2 x 2048 2 x 1024 2 x 512
4 x 1024 4 x 512 4 x 256
8 x 512 8 x 256
10 x 409 NR
1k 0,5k
1 x 512
2 x 256
1 x 512
2 x 256
NR
NR NR
NR NR
P | 14
A G E