Fax/Did Feature - Siemens HiPath 1100 Service Manual

7.2.11

Fax/DID Feature

Provides automatic answering of an external call in addition to message playback and fax
signal detection. A caller can dial any extension or enter any digit configured in the Answering
Menu and be transferred to another extension or group.
The feature has five modes of operation: Fax only, DID, Fax/DID, message and Auto Fax. If a
S0 or TME1 module is also installed, a fourth mode of operation is available: a DID for digital
lines.
Messages stored in this module can be programmed as a Second Attendant for external calls
or as a Forwarding Destination for an Extension (see Call Forwarding in the User Manual). The
maximum number of simultaneous conferences supported by the system is 8.
Call Answering Menu (009)
The Fax/DID lets you create a customized call answering menu transferring the call to an
extension or a group, depending on the number entered.
A call is transferred to a preconfigured destination after 3 seconds. If a digit is entered before
this period of time, it will be analyzed and the call will be forwarded to a new destination. The
destination can be an extension or a group.
When the Call Answering Menu is not configured, the system can only detect extension and
group numbers.
Message Recording (137)
Allows you to record and playback greetings and messages, transfers and alarms. Simply
speak to record or listen to the playback of a message right after the end of the sequence.
To stop the recording or playback of an greeting or message press the key "1".
Call Answering Mode Configuration (127)
The Fax/DID has five modes of operation available for the different messaging requirements.
Fax Reception Extension (128)
Specifies to which extension a call will be transferred when a fax signal is detected on an
external line.
In "Type of Equipment Connected to an Extension - Position 003" you must specify
the extension as a fax extension before programming Code 28.
A31003-K1160-S100-03-7620
Service Manual
Configuring the system specifically for the client
Comments about the System's Programming Codes
7-59