Siemens HiPath 1100 Service Manual page 287

Setting a System Password (180)
Access to the system's Programming Mode is protected by password to prevent unauthorized
access. The default password is "31994." This password can be changed.
Make a note of the new password and store it in a safe place. If you forget the pass-
word, the only way to access programming mode is by asking a support technician
to give you access.
Night Service Password (149)
Independently from the system password, an additional password can be defined for activating/
deactivating different features (e.g., Night Service, relays). The default password is "31994."
This password can be changed.
Restoring Default Settings (199)
Restores all default factory settings. After entering this code, the system will restart. Only the
settings for Country/Group of Countries (Code 65) will be saved as last configured.
Regular Timers and System Timers (139 and 140)
These settings allow you to reset the times for some features and signals according to the
specific characteristics of a user or a country.
DTMF signals for the Relay (177)
When an alarm is triggered, the HiPath 1120 makes a call using the Speed Dial entry 249. The
slot number is called and a sequence of digits in DTMF format is repeated every 5 seconds
immediately after the connection is established. This sequence of 25 digits is used to determine
the source of the alarm so that an alarm exchange, for example, can identify from which PABX
the alarm is coming from. If the receiving exchange does not acknowledge the alarm within 1.5
minutes, the procedure is repeated every 3 minutes.
Emergency Numbers (040)
You can specify up to five emergency numbers. When one of these numbers is dialed and all
external lines are busy, the call on the first external line will be interrupted and the line used for
making the emergency call. Only an incoming call over an analog external line will not be
disconnected.
A31003-K1160-S100-03-7620
Service Manual
Configuring the system specifically for the client
Comments about the System's Programming Codes
7-49