Operation
Programming the system using a PC
5.
Install your selected software components sequentially. For programming the HiPath 1100
system, the following applications must be installed:
HiPath 1100 Manager and
●
CommServer (installs automatically).
●
6.
After installation of each component, a message is displayed indicating that the installation
was successfully completed. Click "Next" every time it appears;
7.
Select "Close" to close the installation window. Installation is then completed and the
computer has to be restarted.
8.
Following the boot sequence, configure the CommServer. Right-click the CommServer
icon on the Windows status bar and select "Properties." Specify these settings:
Connection Type: ISDN Connection via S
●
Phone #: Telephone number to be dialed by CommServer.
●
Your MSN: CommServer MSN.
●
or
Connection Type: ISDN Connection via S
●
Phone #: 800
●
Your MSN: No entry required
●
Figure 6-12
CommServer Properties - Configuration of ISDN Connections
9.
When a HiPath 1100 application is activated, the server starts automatically.
6-17
Trunk
0
Bus
0
A31003-K1160-S100-03-7620
Service Manual