Skoda KODIAQ2016 Owner's Manual page 69

WARNING
If there is a system malfunction the headlights are automatically lowered to
the emergency position, which prevents a possible dazzling of oncoming
traffic. This reduces the cone of light in front of the vehicle. Seek help from
a specialist garage.
Light Assist
Fig. 55 Installation location versions of the sensor / system on/off

Read and observe on page 64 first.
The system automatically switches the high beam on/off in accordance with
the existing traffic (other vehicles) and environmental conditions (e.g. driving
through a lit village).
The high beam on/off is controlled by a sensor or a camera
Activating / Deactivating the system takes place in the Infotainment menu
→  → Light → Light Assist.

Conditions for the system function
The system is activated.

The light switch is in the position .

The vehicle speed is over 60 km/h or for some countries more than 40

km/h.
The windscreen is clean in the sensor area.

Switching on and off
›
To turn onthe system, push the control stalk into the sprung position
» Fig. 55, the warning light  illuminates in the display of the instrument
cluster.
›
Toturn off the automatically switched on main beam, push the lever into the
sprung position
›
To manually switch on the main beam, push the lever into the sprung posi-
tion
A
The headlight switches off automatically when the speed falls below 30 km/h.
If there is a fault, the error message will appear in the instrument cluster dis-
play. Seek help from a specialist garage.
WARNING
The system is used only for support, thus the driver is not released from his
obligation to manually adjust the main or low beam according to the given
ambient conditions (e.g. in unfavourable lighting and weather conditions, as
when passing poorly lit road users, if necessary, when the visual range of
the sensor is limited by an obstacle).
CAUTION
Do not cover the sensor - the system can be affected.
Fog lights/rear fog light
» Fig. 55.

Read and observe
Switching on the fog lights/rear fog lights is possible under the following
conditions.
The lights switch is in position ,  or 

›
To switch on the fog lights, turn the light switch to position
light

A
›
To switch on the rear fog lights, pull the light switch to position
warning light
, the » Fig. 55warning light expires.
B
» Fig. 55, the warning light goes out.
on page 64 first.
illuminates in the instrument cluster.
illuminates in the instrument cluster.

Fig. 56
Light switch – switch on front
and rear fog lights
» Fig. 56.
1 ; the warning
; the
2
Lights and visibility

67