Skoda KODIAQ2016 Owner's Manual page 242

Fig. 300 Segment display: Examples of Speed Limiter status displays

Read and observe on page 239 first.
Status displays of the speed limiter
Speed limit is set, control is inactive (in the colour display the digits of

speed limits is shown in grey).
Control active (in the colour display the digits of the speed limits are high-

lighted).
No speed limit set.

System fault - seek assistance from a specialist garage immediately.

Basic requirements for start of control
The Speed Limiter is activated.

The current speed is greater than approx. 30 km/h.

After starting the system, the current speed is set as the speed limit, the warn-
ing light lights up in the instrument cluster.

Exceeding the speed limit during the regulation
If, during the control, it is necessary to exceed the speed limit (e.g. to over-
take), the accelerator pedal must be pressed fully.
When exceeding the speed limit (e.g. driving down a hill), an acoustic signal
sounds and the warning light flashes in the instrument cluster.

The regulation is resumed once the speed has fallen below the set limit.
240
Driving
» Fig. 299, » Fig. 300
Operation description - Variant without CCS

Read and observe on page 239 first.
Overview of the control elements of the speed limiter
Activate speed limiters
A

Interrupt control (spring-tensioned position)

Disable speed Limiter (delete set limit )

Take control again
B a)

of 1 km/h), hold (in increments of 10 km/h)
Start control/ reduce speed limit - press (in increments of 1 km/h),
C

hold (in increments of 10 km/h)
a)
If no speed limit is set, the current speed is set as the speed limit.
Fig. 301
Controls of the speed limiter
(version without CCS)
» Fig. 301
/ increase speed limit - press (in increments