Skoda KODIAQ2016 Owner's Manual page 196

Estimated time of arrival at destination / remaining driving time to desti-

nation
1)
Remaining distance to the destination

Chosen route type (economic, fastest, shortest)
C
Current vehicle position (address / GPS coordinates)
D
The display of the arrival time or the remaining driving time can be adjusted as
follows.
▶ In the Navigation main menu, tap the function surface  → Advanced settings
→ Time display: Tap.
Several route destinations
In the route plan, the following information is displayed at the respective desti-
nations» Fig. 242 - .
Area with function surfaces
A
Stopover (with sequential number)

Final destination

Estimated time of arrival at destination / stopover

Driving distance to destination / stopover

Change destinations with each other

Delete the destination

Continuation of the route guidance from the selected target (previous

waypoints are skipped)
Display the destination details

Insert destination into the route
In the area Enter dest. Tap the function surface and enter a new destina-
▶ A
tion.
▶ Or: Tap on the area the function surface destinations and select an object in
A
the list of stored destinations.
Each additional destination is added to the list as the first subsequent destina-
tion route.
Change positions of destinations with each other
▶ The relevant function surface  and move the destination to the desired po-
sition.
1)
If the time of arrival to the final destination or remaining travelling time greater than 24 hours,  is displayed
inside the symbol.
194
Infotainment
» page 191
With destinations on the route already reached the note Dest. reached is dis-
played below the destination name. It is not possible to change the position of
these destinations with each other.
Store route
▶ In the area , tap the function surface Save.
A
Save the edited route as a new route or replace the existing saved route.
▶
The route is stored in the route list
Stop route guidance
In the area , tap the function surface stop .
▶ A
Route change in the map
Only valid for Infotainment Columbus.
Fig. 243 Route change in the map / route transit point
A route in which no waypoints are contained, can be changed during route
guidance by adding a transit point.
Add a transit point
›
In the Navigation main menu, tap the function surface  → Change route in map.
›
Touch the screen in the route field and move the cross-point to the desired
location on the map, e.g. , move
A
The transit point B is added to the route
›
Tap the function surface  .
Then a route is recalculated and the route guidance starts.
» page 195.
» Fig. 243).
» Fig. 243.
