Skoda KODIAQ2016 Owner's Manual page 297

There is damage to the tyre wall.
▶
The expiration date (see inflation bottle) has passed.
▶
WARNING
If the sealant comes into contact with skin, wash the affected area imme-
■
diately.
Observe the manufacturer's usage instructions for the breakdown kit.
■
Description of puncture repair kit
Fig. 349 Description of puncture repair kit

Read and observe on page 295 first.
The kit is located in a box under the floor covering in the luggage compart-
ment.
Sticker with speed designation "max. 80 km/h"/"max. 50 mph"
1
Valve remover
2
Inflation hose with plug
3
Air compressor (the layout of the controls may be different depending on
4
the type of air compressor delivered with the vehicle)
Button for the tyre pressure reduction
5
12 volt cable connector
6
7 Tyre inflation hose
Tyre inflation pressure indicator
8
ON and OFF switch
9
Tyre inflation bottle with sealing agent
10
Replacement valve core
11
Note
The declaration of conformity is included with the air compressor or the log
folder.
Preparing to use the puncture repair kit

Read and observe on page 295 first.
For safety's sake, the following instructions must be observed before
performing a wheel repair the road.
›
As far as possible, park the vehicle far away from the traffic flow - find a
place with a flat and firm surface.
›
Switch off the engine.
›
For vehicles with manual transmission, select 1st gear.
›
For vehicles with automatic transmission, place the selector lever in the P
position.
›
Switch on the parking brake.
›
Position the hazard warning system and the warning triangle at the prescri-
bed distance.
›
All the occupants should get out of the vehicle. The passengers should not
stand on the road (instead they should remain behind a crash barrier, for in-
stance) while the wheel is being repaired.
›
Uncouple any trailers.
Sealing and inflating tyres

Read and observe on page 295 first.
Sealing
›
Unscrew the valve cap from the damaged tyre.
›
Insert the valve remover » Fig. 349
2
that the valve insert fits into the slot of the valve remover.
›
Unscrew the valve insert and lay it on a clean surface (e.g. cloth, paper etc.).
›
Forcefully shake bottle several times.
10
›
Firmly screw the inflation hose
on the cap is pierced automatically.
on page 295 on the valve insert, so
onto the tyre inflater bottle
3 10
Emergency equipment and self-help
. The film

295