Skoda KODIAQ2016 Owner's Manual page 228

Activation/deactivation

Read and observe and
Activation
The system is activated by selecting reverse gear or pressing the symbol 
button» Fig. 278.
When activating, an alarm sounds and the symbol
The display mode for the traverse parking is displayed.
Deactivation
The system is deactivated by pressing the  button, switching off the ignition
or when the speed exceeds 15 km/h (the
out).
Function surfaces

Read and observe and
It is possible to adjust the parking and manoeuvring mode by means of the
function surfaces.
226
Driving
Fig. 278
Button for activation / deactiva-
tion
on page 225 first.
illuminates in the button.

symbol in the button then goes

Fig. 279
Function surfaces
on page 225 first.
Function surfaces » Fig. 279
Turns off the display of the area behind the vehicle
A
Mode - traverse parking
B
Mode - parallel parking
C
Mode - driving up to a trailer / distance monitoring
D
Mode - monitor the area behind the vehicle (wide view)
E
Screen settings - brightness, contrast, colour
F
Parking aid (thumbnail display)
G
   Switch thumbnail display on/off
Touching the vehicle silhouette toggles to full screen display on the
screen.
Orientation lines and lane

Read and observe and
In the modes for transverse and parallel parking guidance, orientation lines for
the assessment of distance and lane lines are displayed on the screen.
Screen display » Fig. 280
The distance is about 40 cm (safety distance limit).
A
The distance is about 100 cm.
B
The distance is about 200 cm.
C
The lane lines terminate approximately 300 cm behind the vehicle.
D
The distance may vary slightly depending on the load of the vehicle and the
road inclination.
The distance between the side lines corresponds approximately to the vehicle
width including mirrors.
Fig. 280
Orientation and lane lines
on page 225 first.
