WARNING
The CD/DVD player is a laser product.
■
This laser product is the date of manufacture in accordance with nation-
■
al / international standards DIN EN 60825-1: 2008-05 and DHHS Rules 21
CFR. Subchapter J classified as Class 1 laser product. The laser used in this
class 1 laser product is so weak that there is no risk of danger when operat-
ed correctly.
This product is designed such that the laser is restricted to the inside of
■
Infotainment. However, the installed laser could be classified in a higher
class were the housing to be removed. For this reason, never remove the
Infotainment housing.
CAUTION
Be sure to remove the CD/DVD before you try to insert a new CD/DVD. Oth-
■
erwise you can damage the drive inside Infotainment.
Only insert in the CD/DVD drive original Audio CDs/video DVDs or standard
■
CD-R/RWs or DVD±R/RWs.
Do not affix anything to the CD/DVDs!
■
If the ambient temperature is too high or too low, the CD / DVD playback
■
may not work.
Damp (condensation) may affect Infotainment in cold weather or high hu-
■
midity. This can cause the CD to jump or impair the play function. Once the
moisture has dissipated, playback is fully functional again.
Note
After pressing the button it takes a few seconds for the CD / DVD to be
■
ejected.
On uneven or unpaved roads, playback jumps may occur.
■
If the CD/DVD is physically damaged, unreadable or is inserted incorrectly,
■
the following message Error: CD/DVD is displayed on the screen.
It is possible that CD/DVDs protected by copyright cannot be played back at
■
all or only in certain circumstances.
SD card
›
Insert the SD card in the slot in the direction of arrow (with the cut end fac-
ing right), until this "locks"
» Fig. 181 » Fig.
›
To remove the SD card, tap the function surface in the Media main menu
→ Remove safely.
›
Press on the inserted SD memory card. The SD card "jumps" into the eject
position.
CAUTION
Do not use an SD card with a broken write protection slide - there is a risk of
■
damage to the SD card reader!
When using an SD card with an adapter, vehicle vibrations might cause the
■
card to fall out of the adapter.
USB input
The exact installation point of the USB input marked with
The USB input audio source can be connected directly or via a connecting ca-
ble.
Fig. 181
Infotainment Columbus,
Amundsen, Bolero: insert SD
card
Fig. 182
Infotainment Swing: insert SD
card
182.
» page
88.
147
Media