Skoda KODIAQ2016 Owner's Manual page 226

Fig. 276 Driving situation / indicator light in the right outside mirror in-
dicates the driving situation

Read and observe and
In the following situations, the indicator light in the outside mirror indicates a
vehicle in the "blind spot".
▶ You vehicle is being overtaken by vehicle
B
▶ Your vehicle overtakes the vehicle
C
km» Fig. 276. If the speed during the overtaking is even higher, then there is
no warning by the warning light.
The warning display is always in the exterior mirror on the side of the vehicle
where a vehicle is detected in the "blind spot".
The greater the speed difference between the two vehicles, the earlier the
warning (by means of the warning light) regarding the vehicle that is overtak-
ing you takes place.
Two warning levels
light up - a vehicle has been detected in the "blind spot".

flash - a vehicle has been detected in the "blind spot" and the turn signal is

switched on.
An advanced warning for vehicles with Lane Assist
flash also if the steering wheel is turned in the direction of the vehicle in

the "blind spot" . Therefore the Lane Assist
the boundary line between the vehicles detected.
If in this case your vehicle indicates crossing the boundary line, with a short vi-
bration of the steering wheel.
224
Driving
on page 222 first.
» Fig. 275.
A
at a greater speed of max. 10
D
» page 252 must be enabled and
Note
The brightness of the indicator light
cle lighting. With the low or high beam on the brightness of the light will be
lower.
Activation / deactivation

Read and observe and
The activation or deactivation of the system can be carried out in one of the
following ways.
In the instrument cluster display
▶
In the Infotainment in the menu
▶
wizard for "Blind Spot" Monitoring).
▶ In the Infotainment in the menu
Rear Traffic Alerts).
After switching off and switching on the ignition, depending on the setting pri-
or to switching off the ignition, the systems remains activated / deactivated.
Note
When activating the wizard for "blind spot" monitoring, the
illuminate briefly in the two exterior mirrors.
Malfunctions

Read and observe and
If the systems are not available for some unknown reason, an appropriate mes-
sage appears in the display of the instrument cluster.
Sensor covered / dirty
If the sensor is dirty or covered, a message indicating that there is no sensor
view appears. Clean or remove the obstructing object from the sensor envi-
ronment » Fig. 273 on page 222.
Systems unavailable
If the systems are currently unavailable, a message regarding the unavailability
appears. Stop the vehicle, switch off the engine and then start it again. If the
systems are still not available, seek the assistance of a specialist garage.
is dependent on the setting of the vehi-

on page 222 first.
» page 48, Menu itemAssist systems.
→  → Driver assistance (Applies to the

→  → Parking and manoeuvring (Applies to

warning lights

on page 222 first.
