Siemens SINUMERIK 840D sl Operating Manual page 91

Note
Settable work offsets
The labeling of the softkeys for the adjustable work offsets varies, i.e. the selectable work
offsets configured at the machine are displayed (examples: G54...G57, G54...G505,
G54...G599).
Please refer to the machine manufacturer's specifications.
Automatic measurement
Milling
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
- OR -
13. Press the "Set WO" softkey.
The corner point now corresponds to the setpoint position. The
calculated offset is stored in the work offset.
1. Prepare the measurement (see steps 1 to 6 above).
2. Approach measuring point P1 with the workpiece probe and press the
<CYCLE START> key.
This starts the automatic measuring process. The position of measuring
point 1 is measured and stored.
The "P1 stored" softkey becomes active.
3. Repeat the operation to measure and store points P2 and P3.
If you are measuring a corner not equal to 90°, repeat the procedure to
measure and store point P4.
4. Press the "Calculate" softkey.
The corner point and angle α are calculated and displayed.
- OR -
Press the "Set WO" softkey.
The corner point now corresponds to the setpoint position. The
calculated offset is stored in the offset target that you have selected.
Setting up the machine
2.6 Measuring the workpiece zero
91