Creating A New G Code Program - Siemens SINUMERIK 840D sl Operating Manual

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Creating a new G code program

You can create G code programs and then render G code blocks for them in a

directory/workpiece.

Operating Manual, 09/2011, 6FC5398-7CP40-2BA0

Select the "Program manager" operating area.

Select the desired storage location and position the cursor on the folder,

in which you would like to create a workpiece.

Press the "New" softkey.

The "New workpiece" window appears.

If necessary, select a template if any are available.

Enter the desired workpiece name and press the "OK" softkey.

The name may be a maximum of 24 characters long.

You can use any letters (except umlauts), digits or the underscore

The directory type (WPD) is set by default.

A new folder with the workpiece name will be created.

The "New G code program" window will open.

Press the "OK" softkey again if you want to create the program.

The program will open in the editor.

Select the "Program Manager" operating area.

Select the desired storage location and position the cursor on the folder,

in which you would like to store the program.

Press the "New" softkey.

13.4 Creating a directory/program/job list/program list

Program management

Sinumerik 828d