Selection Of The Cycles Via Softkey - Siemens SINUMERIK 840D sl Operating Manual

Creating G code program

6.8 Selection of the cycles via softkey

6.8 Selection of the cycles via softkey
Overview of machining steps
The following softkey bars are available to insert machining steps.
All of the cycles/functions available in the control are shown in this display. However, at a
specific system, only the steps possible corresponding to the selected technology can be
selected.
218
⇒
⇒
⇒
⇒
⇒ ⇒
Operating Manual, 09/2011, 6FC5398-7CP40-2BA0
Milling