When Using Both The Master Function And Slave Function - Mitsubishi QJ71DN91 User Manual

4 SETUP AND PROCEDURES BEFORE OPERATION

4.1.3 When using both the master function and slave function

Yes
Create "parameters for the master
function" using GX Configurator-DN.
Create "parameters for the slave
function" using GX Configurator-DN.
Set "auto communication start
settings" using GX Configurator-DN
and load it to the QJ71DN91.
Set "auto refresh" using GX
Configurator-DN and load it to the
QCPU.
Create a sequence program for
control.
Load the sequence program to the
PLC CPU and reset.
Trial run?
OK
: It is necessary to install a DeviceNet network and turn ON the power in advance.
4 - 3
Start
Perform a hardware test (mode 9).
Set to mode 0 to 2.
Use
GX Configurator-DN?
Create "parameters for the
master function" using a
sequence program.
Create a sequence program for "auto communication start
settings" and save it in the flash ROM of the QJ71DN91.
NG
End
No
Create "parameters for the
master function" using auto
configuration. ( )
Change the
number of I/O points of
the slave?
Yes
Create a sequence program to change
the number of I/O points of the slave.
Create a sequence program for
refresh.
Create a sequence program for
control.
Load the sequence program to the
PLC CPU and reset.
Trial run?
OK
Save the parameters using a
sequence program (Y17).
MELSEC-Q
Creating the
parameters for the
master function
No
Creating the
parameters for the
slave function
Setting the
presence of auto
communication
Setting refresh
NG
4 - 3