Table of Contents
Advertisement
6 UTILITY PACKAGE (GX Configurator-DN)
6 - 19
[Explanation of items]
(1)
Description of screen display
Setting item
: Displays the I/O signal and buffer memory names.
Current value
: Monitors the I/O signal status and present buffer memory
Setting (value) : Enter or select the value to be written into the buffer memory
(2)
Explanation of the command buttons
Write to module
Read from module
File save
File read
Current value display
Make text file
Start monitor /
Stop monitor
Execute test
Close
REMARK
The following explains the selective test operation, using an example of writing to
"Down Node Detection Inhibit Settings".
(1)
Change the setting value field from "1 node" to "Do not detect".
Nothing is written to the QJ71DN91 at this point.
(2)
Click the setting value field showing "1 node" to select.
To write more than one setting item at the same time, select multiple items
while holding down the Ctrl key.
(3)
Click Execute test to execute the write operation.
When the write operation is complete, the display in the current value field will
change to "Do not detect".
value.
with test operation.
Writes the parameters into the flash ROM of the
QJ71DN91.
Reads the parameters from the flash ROM of the
QJ71DN91.
Saves the parameters in the hard disk, etc.
Reads the parameters saved in the hard disk, etc.
Displays the current value of the item selected. (This is
used to check text that cannot be displayed in the
current value field. However, in this utility package, all
items can be displayed in the display fields).
Creates a file consisting of the screen data in text file
format.
Selects whether or not the current values are
monitored.
Performs a test on the selected items. To select more
than one item, select them while holding down the Ctrl
key.
Closes the screen that is currently open and returns to
the previous screen.
MELSEC-Q
6 - 19
Advertisement
Table of Contents
