Setting Parameters Using The Sequence Program - Mitsubishi QJ71DN91 User Manual

8 PROGRAMMING WHEN EXECUTING THE SLAVE FUNCTION

8.2 Setting Parameters Using the Sequence Program

This section explains an example of a sequence program for setting parameters.
Command for setting
parameters for the
slave function
8 - 2
MELSEC-Q
Sets the number of reception bytes
to 16 bytes.
Sets the number of transmission bytes
to 16 bytes.
Writes the parameter data into the
buffer memory.
I/O communication
start command
Command for setting
parameters for the
slave function
8
8 - 2