Grounding Cable Specifications; Acx1100 Ac Power Specifications; Acx1100 Ac Power Cord Specifications; Planning Power Requirements - Juniper acx1000 User Manual

Grounding Cable Specifications

Related
Documentation

ACX1100 AC Power Specifications

Related
Documentation

ACX1100 AC Power Cord Specifications

Copyright © 2017, Juniper Networks, Inc.
You must provide one grounding cable that meets the following specifications: 6-AWG
2
(4.11 mm ), minimum 90°C wire, or as required by the local code.
Connecting the ACX1000 or ACX1100 Router to Earth Ground on page 103
Preventing Electrostatic Discharge Damage to an ACX1000 or ACX1100 Router on
page 158
Table 21 on page 59 lists the AC power system electrical specifications.

Table 21: AC Power System Electrical Specifications

Item
AC input voltage
AC input line frequency
AC system current rating
AC system input power
Maximum AC power supply output
NOTE: We recommend that you use a dedicated customer site circuit breaker
rated for 2 A (100 VAC) or 1 A (240 VAC), or as required by local code. Doing
so enables you to operate the router in any configuration without upgrading
the power infrastructure.
ACX1100 AC Power Cord Specifications on page 59
Each AC power supply has a single AC appliance inlet that requires a dedicated AC power
feed. Most sites distribute power through a main conduit that leads to frame-mounted
power distribution panels, one of which can be located at the top of the rack that houses
the router. An AC power cord connects each power supply to the power distribution panel.
You can order detachable AC power cords, each approximately 8 ft (2.5 m) long that
supply AC power to the router. The C15 appliance coupler at the female end of the cord,
as described by International Electrotechnical Commission (IEC) standard 60320, inserts
Chapter 8: Planning Power Requirements
Specification
Operating range: 100 to 240 VAC
50 to 60 Hz (nominal)
2 A (100 VAC) or 1 A (240 VAC)
85 W
70 W
59