Juniper acx1000 User Manual page 145

Copyright © 2017, Juniper Networks, Inc.
Slide the transceiver until the connector is seated in the component slot. If you are
5.
unable to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
6.
Remove the rubber safety cap from the transceiver and the end of the cable. Insert
7.
the cable into the transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Verify that the status LEDs on the front panel indicate that the transceiver is functioning
8.
correctly. For more information about the component LEDs, see the
and ACX1100 Routers" on page
Chapter 16: Installing and Replacing Components
35.
"LEDs on ACX1000
127