Epson PX-8 Technical Manual page 260

REV.-A
(c) Cut the lead wire to the proper length and do not short-circuit it to other lands.
x
• Lead wire must be
projected from the
through hole.
6.3.3 Installing the Parts
Q)
Proper
CD
Proper
CD
Do not allow the part to contact the board.
x
X
• As a rule, do not • Lead wire must not
bend the lead wire. be too long.
Fig. 6-3
Fig. 6-4
®
Install the part in parallel with the surface of the board (The limit of slanting angle is 15°).
CD
Do not install the part too far from the surface of the board (to prevent it from short-circuiting other parts).
6-5