Epson PX-8 Technical Manual page 184

REV.-A
Lock
button
cover
Board
Disassemble Procedure
Step 1. Remove keyboard cover.
Stpe 2. Place the body as shown in Fig. 4-2,
and remove screw pointed by arrow.
Step 3. Lift up cover slowly from right side.
Step 1. Remove lock button cover.
Step 2. Remove connector.
Step 3. Remove FPC cable from connector
CN4.
Step 4.
Remove cables from
CD, CD
and
CD.
Step 5. Remove three screws pointed by ar-
rows.
Step 6. Lift up board slowly from your side.
Fig. 4-3
Fig. 4-4
4-3
Assemble Procedure
Perform the reverse procedure to disassem-
ble.
Fig. 4-2
Step 1. Place PX-8 with lower case being
removed.
Step 2. Put jack connector
CD
into specified
hole.
Step 3. Place board slowly.
Step 4. Fit three screws pointed by arrows.
Step 5. Fit cables to connectors
CD, CD
and
CD.
Step 6. Remove lock button cover and
insert the FPC cable to connector
(CN4).
Step 7. After fitting the cable to the connec-
tor
CD,
insert cable between case
and boss paying attention not to
damage the cable. (see Fig. 4-4.)
-~