9.
Close the front cover.
10. The machine automatically starts the initial toner supply.
It takes about one to two minutes to finish the initial toner supply. If the toner has not
been shaken well, it may take up to about 10 minutes.
If a toner bottle has not been set, the machine does not work because there is a
toner bottle set detection mechanism.
If you turn on the machine without closing the front cover, the initial toner supply is
not performed at installation, and the machine goes to the toner end condition even if
the machine has plenty of toner in the toner bottle.
11. Enter SP mode again, and then press [System Sp].
12. Enter SP7-622-250 (PM Counter Reset: SCS), and then press [Execute].
SM
2-17
D197/D198/D199/D200/D201/D202
Main Machine Installation