Scanner Unit
4.
Coil up the ball-shaped end of the wire clockwise (when looking at the boss of the
pulley) three and half times, next to the rim at the front side of the pulley.
5.
Make sure that blue markings of the wire are aligned, and then fix the wire temporarily
with tape.
6.
Set the pulley [A] on the drive shaft [B] (
Fasten the screw temporarily.
7.
Set the ball-shaped end of the wire with the following procedure.
1. Route the wire from under side of the pulley [A] of the left frame toward the upside and
hook the wire on the outer edge of the pulley [A].
D197/D198/D199/D200/D201/D202
×1,
×1, bearing × 1).
4-50
SM