USB Device Server Option Type M12
⇒
10. Access the option's IP address from a PC browser and check to see that the option is
detected correctly by following steps 10a through 10d..
When Installing the USB Device Server Option Type M12, the installation status is
not shown on Configuration Page.
10a. Access the option's IP address from a PC browser.
10b. Ping the option's IP address from a command prompt on a Windows PC in the same
network as the D197 series machine.
• If IP address cannot be found (DHCP server), use the MAC address. This is the
number printed on the seal affixed to the printed circuit board for the USB server.
10c. Use "RX" + the option's MAC address and access a PC browser.
EX. http://RX0080926A3264
D197/D198/D199/D200/D201/D202
2-236
Rev. 04/16/2015
SM