System Components; Site Log - Cisco 7000 Series Hardware Installation And Maintenance Manual

Step 3
Step 4
Step 5
Step 6

System Components

Table 2-16 lists all of the standard components that are included with the router and the optional
equipment available. Check each item on the Component List as you unpack and verify it. Insert the
completed checklist into the Site Log, which is described in the following sections.

Site Log

A site log provides a historical record of all actions relevant to the router operation and maintenance.
Keep your site log in a common place near the chassis where anyone who performs tasks has access
to it. Site Log entries might include the following:
•
Installation progress—Make a copy of the Installation Checklist and insert it into the Site Log.
Make entries on the Installation Checklist as each procedure is completed.
•
Upgrades and removal/replacement procedures—Use the Site Log as a record of system
maintenance and expansion history. Each time a procedure is performed on the system, update
the Site Log to reflect the following:
— Interface processors installed, removed, or replaced.
— Power supply removed or replaced.
— Configuration changed (moving interface processors or moving network interface cables
— Software or microcode (firmware) upgraded—Insert any documentation that accompanies
— Corrective maintenance procedures performed.
— Intermittent problems.
— Related comments.
Table 2-18 shows a sample Site Log page. Make copies of the sample or design your own Site Log
to meet the needs of your site and equipment.
Check the processor slots and verify that the top slot contains an RP, and the slot directly
below the RP contains an SP (or SSP). (See Figure 1-3.)
Each of the lower three processor slots (the interface processor slots) each contain an
interface processor or a blank interface processor filler. Verify that the configuration
matches the packing list and that the interface processors are the correct interface types with
the correct number of ports.
This step is optional. Complete the Port Configuration Worksheet shown in Table 2-17.
Check the interface processors in the rear of the chassis and record the interface type for
each populated interface address. You may need to refer to this worksheet during
installation.
Proceed to the section "Site Log" in this chapter, then to the chapter "Installing the Router"
to begin installation.
between ports).
upgrades, spares, or new components, such as installation procedures, in the Site Log when
you complete the procedure.
Initial Configuration Information
Preparing for Installation 2-47