Installing A Compact Flash Memory Card - Cisco 2010 Hardware Installation Manual

Removing and Installing Compact Flash Memory Cards
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Figure 5-4
1
Step 3 Press the ejector button again. See
of its slot.
Step 4 Pull the compact flash memory card out of its slot.
Push the ejector button in until the button is flush with the bezel.
Step 5
To prevent damage to the ejector mechanism, the ejector button must remain pressed in all the way (flush
Caution
against the bezel) when not being used to eject a compact flash memory card.

Installing a Compact Flash Memory Card

To install a compact flash memory card, perform the following steps:
Make sure that the ejector button is fully seated until it is flush with the bezel.
Step 1
Note
Insert the compact flash memory card into the slot until it is fully seated. The ejector button remains
Step 2
flush with the panel.
Cisco Connected Grid Routers 2010 Hardware Installation Guide
5-6
Compact Flash Memory Card Slot in Cisco 2010 CGR
P S U 2
C F 1
D O N O T
R E M O V
E D U R IN
N E T W O
G
R K O P E
R A T IO N
D O N O T
R E M O V
E D U R IN
N E T W O
R K O P E
R A T IO N
Ejector button
If the ejector button is projecting out from the panel, push it in until it is flush with the bezel.
C F 0
G
1
2
2 Compact flash slot
Figure 5-4. This ejects the compact flash memory card part-way out
Chapter 5 Installing and Upgrading Internal Modules
P S
T y p e
L o V D C
H i V D C
o r
V A C
C is c o C
o n n e c t e
d
OL-21559-01