Sending Data Setting - Pentax R-422VN Instruction Manual

the definition of the "Coord. Axis" between settings in "Communication setup" and
settings in "Coordinate axis definition" when same coordinate systems are used.
• Factory default setting of RECEIVING
1. BAUD RATE:
2. DATA LENGTH:
3. PARITY BITS:
4. STOP BITS:
5. SIGNAL CONTROL:
6. XON/XOFF:
7. PROTOCOL:
8. RECORD DELIMETER:
9. DISP.1 AXIS:
10. DISP.2 AXIS:
11. DISP.3 AXIS:
12. ROTATION:

12.3.3.2 Sending data setting

Select the 4. COMMUNICATION SETUP and press
[ENT] to view the COMM. SETTING
SELECTION.
[2. SEND RECT. DATA]
Select the 2. SEND RECT. DATA and press [ENT]
to view the following screen.
Press [ENT] to open the selection window. Select
each setting and press the [ENT].
Press [ACCEPT] when all selections are made.
• DISP.# AXIS: BASIS DIRECT, RIGHT ANGLE, or HEIGHT is selected when data
is transferred between the TS and PC. (cfr. "13.2 Coordinate axis definition")
1200
8
NIL
1
ON
ON
ON
CR
BASIS DIRECT.
RIGHT ANGLE
HEIGHT
CW
123